> > 4 Channel Adaptive Video Equaliser, automatic correction up to 1mile (1.6km) with Cat5e/Cat6 Shielded and Unshielded Cable (BH260)

4 Channel Adaptive Video Equaliser, automatic correction up to 1mile (1.6km) with Cat5e/Cat6 Shielded and Unshielded Cable (BH260)

bh260 The BH260 unit will automatically equalise a video signal at the push of a button and deliver a high quality video signal over Cat5e/6 cable of up to 1 mile (1.6km). Only a passive balun is required at the camera and this is supplied free of charge along with the 12V DC power supply.

• Fully automatic, no user adjustment required
• Automatic polarity detection and inversion
• Automatically restores settings on power up
• Automatic cable type compensation
• Low power consumption
• No set-up test equipment required
• Simple and quick installation
• 4 Channels
• 19" Rack Mountable

TECHNICAL	DESCRIPTION
INPUT SIGNAL TYPE	Balanced composite video signal. NTSC or PAL
INPUT IMPEDANCE	100 Ohm
OUTPUT SIGNAL	1.0V Pk-Pk @ 75 Ohm
SIGNAL INPUT CONNECTOR	4 x Spring-loaded connector, maximum cable size 1.3mm²
SIGNAL OUTPUT CONNECTOR	4 x BNC male type coax connector
AT UNITY GAIN	Differential Phase <1º. Differential Gain <1%
BANDWIDTH	40Hz to 6MHZ
PERFORMANCE	Will equalise a video signal on the following cable types: Cat5e/6 Unshielded Twisted Pair up to 1 mile (1.6km) Cat5e/6 Shielded Twisted Pair up to 1 mile (1.6km) Standard BT Cable 1/2 mile (800m) *If you have a specific cable you would like us to test, please contact us at the address below.
POLARITY DETECTION	Automatic detection & correction of inverted input
SURGE PROTECTION	Transorbs and gas tubes fitted as standard
POWER REQUIREMENTS	12V DC @ 450mA
POWER SUPPLY	Included, international plug top switch-mode regulated power supply 90 – 265Vac power consumption nominally 13 Watts. Supplied with ‘country specific’ input connector.
POWER CONNECTOR	Screw terminal maximum cable size 4mm² loaded screw less terminal block
OPERATING TEMP	-30ºC to +45ºC
CONTROLS	Auto setup button
INDICATOR LED’s	Green LED indicates power Yellow LED indicates signal equalised and ‘SET’
DIMENSIONS	19” x 1.5U x 25mm (excluding BNC connectors)
MOUNTING	Via 2 x 3.5mm holes for convenient screw fixing

Ordering Information:
For a quotation, further details or technical support and advice, contact us by phone on +44 (0)1483 480969, fax +44 (0)1483 797268 or email us, quoting part number BH260.

Products available for use with BH260:
BH207 Video Distribution Amplifier, 1in 4out